EasyManuals Logo

IKEA ADRATT User Manual

IKEA ADRATT
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
40
EN
BEFORE YOU CALL
Solutions to Common Problems
Before you call for service, review the following list. It may save you time and expense. Possible solutions
are provided with the problem listed
Problem Cause / Solution
Entire appliance does not
operate
Appliance not connected. Make sure power cord is plugged properly into out-
let. Check your fuse box or breaker box to make sure the circuit is active.
Electrical power outage. Check house lights to be sure. Call your local electric
company for service outage information.
Problem Cause / Solution
Oven control panel beeps
and displays error codes
Oven control has detected a fault or error condition.
When this occurs an E or F will show in the display.
Press OFF: Activate a Bake or Broil.
If the F or E code error repeats, turn off power to appliance, wait 5 minutes
and then repower appliance. Set clock with correct time of day.
Try Bake or Broil function again. If a fault code appear again, press OFF to
clear the error code and contact your servicer.
Poor baking results. Many factors effect baking results.
Use proper oven rack position.
Center food in the oven and space pans to allow air to circulate.
Preheat oven to the set temperature before placing food in the oven.
Try adjusting the recipe’s recommended temperature or baking time. See
Adjusting Oven Temperatures” on page 32 if you feel the oven is too hot
or cold.
Quick Preheat performs
poorly
Quick Preheat not used correctly. This cooking function is intended for con-
venience, precooked, and other speci c foods. See “Quick Preheat” on page
16 and follow tips for best using this feature.
Appliance is not level Poor installation. Place oven rack in center of oven. Place a level on the oven
rack to check if oven has been properly installed.
Kitchen cabinet alignment may make oven appear not level. Be sure cabinets
are square and have suf cient room for appliance clearance.
If cabinets are not square or are built in too tightly, contact builder or install-
er to make appliance accessible.
Cannot move appliance
easily
Appliance must be acces-
sible for service
Cabinets not square or are built in too tightly.
Contact builder or installer to make appliance accessible.
Appliance does not oper-
ate
Electrical power outage. Check house lights to be sure.
Call your local electric company for service outage information.
Service wiring is incomplete. Call (833) 337-4006 for assistance.

Table of Contents

Other manuals for IKEA ADRATT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IKEA ADRATT and is the answer not in the manual?

IKEA ADRATT Specifications

General IconGeneral
BrandIKEA
ModelADRATT
CategoryOven
LanguageEnglish

Related product manuals