40
BASIC SETTING DISPLAY
TEXT
SELECTION DESCRIPTION
Time-beam-on-
floor
S:01 S:00 - S:01 Switch Time-beam-on-floor on
or off.
While the programme is run-
ning, status information is
projected onto the floor be-
low the appliance door relat-
ing to timer programming,
the programme or the time
remaining. If the base panel is
pulled forwards or if the ap-
pliance is installed at eye level
with the cabinet front fitted
flush, the display is not vis-
ible.
Level "S:00" switches the
Time-beam-on-floor of.
Start programme SP:01 SP:00 - SP:01 Set a default programme for
when the appliance is
switched on.
● With the setting "SP:00",
the last programme selec-
ted is set by default for
when the appliance is
switched on.
● With the setting "SP:01",
the Eco 50° programme is
set by default for when the
appliance is switched on.
Tone volume SL:02 SL:00 -SL:03 Adjustment of tone volume.
End of programme indicated
by an audible signal tone.
Level "SL:00" switches the sig-
nal tone off.
Button volume bl:02 bl:00 - bl:03 Set the button volume during
operation. Level "bl:00"
switches the button tones off.
Factory setting rE
Start with
Restore changed settings to
the factory settings.
The settings for initial start-up
must be configured.
To Next Page
Loading...
Need help?
General
