48
FAULT CAUSE TROUBLESHOOTING
Appliance interior still
wet after wash cycle.
Not a fault. The con-
densation drying prin-
ciple causes water
droplets in the tub –
they are indeed desir-
able here. The mois-
ture in the air con-
denses on the inside
walls, runs off and is
pumped out.
No action required.
Remnants of food on
tableware.
Tableware was placed
too close together.
1. Arrange tableware with suffi-
cient space in between.
The spray jets must reach
the surfaces of the table-
ware.
2. Avoid points of contact.
Basket is overfilled. 1. Arrange tableware with suffi-
cient space in between.
The spray jets must reach
the surfaces of the table-
ware.
2. Avoid points of contact.
Spray arm rotation is
blocked.
● Arrange tableware so that it
does not obstruct spray arm
rotation.
Spray arm nozzles are
blocked.
● Clean the Spray arms
→Page43.
Filters are soiled. ● Clean the filters.
→"Cleaning filters", Page42
Filters are inserted in-
correctly and/or not
engaged.
1. Insert the filters properly.
→"Filter system", Page42
2. Engage the filters.
Washing programme
selected too weak.
● Select a more intensive
washing programme.
● Adjust the sensitivity of the
sensors.
Tableware has been
precleaned too in-
tensely. The sensors
chose a weaker pro-
● Only remove large remnants
of food and do not prerinse
tableware.
To Next Page
Loading...
Need help?
General
