6
- The longer cord should be arranged so that it will not
drape over the countertop or tabletop where it can
be tripped over, snagged, or pulled on by children or
tripped over unintentionally.
Federal Communications Commission Radio
Frequency Interference Statement (U.S.A.
Only)
This equipment generates and uses ISM frequency
energy and if not installed and used properly, that is in
strict accordance with the manufacturer’s instructions,
may cause interference to radio and television reception.
It has been type tested and found to comply with limits
for ISM Equipment, pursuant to part 18 of FCC Rules,
which are designed to provide reasonable protection
against such interference in a residential installation.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference
by one or more of the following:
- Reorient the receiving antenna of the radio or
television.
- Relocate the microwave oven with respect to the
receiver.
- Move the microwave oven away from the receiver.
- Plug the microwave oven into a different outlet so
that the microwave oven and the receiver are on
different branch circuits.
The manufacturer is not responsible for any radio
or television interference caused by unauthorized
modification to this microwave oven. It is the
responsibility of the user to correct such interference.
GROUNDING INSTRUCTIONS
RADIO INTERFERENCE
1. Operation of the microwave oven may cause
interference to your radio, TV or similar equipment.
2. When there is interference, it may be reduced or
eliminated by taking the following measures:
1) Clean door and sealing surface of the oven
2) Reorient the receiving antenna of radio or
television.
3) Relocate the microwave oven with respect to the
receiver.
4) Move the microwave oven away from the receiver.
5) Plug the microwave oven into a different outlet so
that microwave oven and receiver are on different
branch circuits.
This MWO may be adapted to a built-in installation
by using Trim Kit (705.427.30/905.427.29), refer to
Trim Kit Installation
Instruction for details.
WARNING
Liquids such as water, coffee, or tea can be overheated
beyond the boiling point without appearing to be
boiling due to surface tension of the liquid. Visible
bubbling or boiling when the container is removed
from the microwave oven is not always present. THIS
COULD RESULT IN VERY HOT LIQUIDS SUDDENLY
BOILING OVER WHEN THE CONTAINER IS
DISTURBED OR A UTENSIL IS INSERTED INTO THE
LIQUID.
To reduce the risk of injury to persons:
1. Do not overheat the liquid.
2. Stir the liquid both before and halfway through
heating it.
3. Do not use straight-sided containers with narrow
necks.
4. After heating, allow the container to stand in the
microwave oven for a short time before removing
the container.
5. Use extreme care when inserting a spoon or other
utensils into the container.
CHOOSING A LOCATION FOR YOUR
MICROWAVE OVEN IF BUILT-IN
Microwave Models:
705.427.06 Black SS
705.427.30 SS
905.427.29 Black SS
SS
Microwave
30" Trim Kit
30" Trim Kit
Microwave
905.427.05
Color
Description
Model Number
Built-In Trim Kit allows for the installation of microwaves listed below to be built into a cabinet or wall by itself or over
an electric wall oven*.
WARNING
*NOTE: Trim Kit and microwave can only be built-in over an electric self-clean or non self-clean single cavity wall oven.
To Next Page
Loading...
