IKEA TILLREDA - Programme Operation and Control

EN - 20
7.1. Changing a Programme
Follow the steps below if you would
like to change the programme while in
operation.
Open the door and select a new
program using the Programme
Selection button.
After closing the door , the newly
selected programme will resume the
course of the old programme.
NOTE: Open the door slightly at first
to avoid water spillage if you wish to
stop the wash programme before it is
complete.
7.2. Cancelling a Programme
Follow the steps below if you would
like to cancel a programme while in
operation.
=
=
Press and hold the Programme Selection button
for 3 seconds. "1" will be shown on the display.
After closing the door of the machine,
the water discharge process will start
and continue for 30 seconds.When the
programme is cancelled, a buzzer will
sound 5 times and the.
Open the door of your machine.
The selected programme will
appear on the display.
7.3. Switching the Machine Off
=
"00" will be shown on the display when the
selected programme is complete. Buzzer will also
sound 5 times. You can then switch your machine
off using the Power On/Off button.
Disconnect the plug and turn off the
water tap.
NOTE: Do not open the door before
the programme is complete.
NOTE: If the door of the machine
is opened or the power is cut off while
a programme is in operation, the
programme will continue when the door
is closed or the power returns.
NOTE: If the power is cut or the
machine door is opened during the
drying process, the programme will
terminate. Your machine will now be
ready for a new programme selection.
Buzzer Sound Control
To change the buzzer sound level, follow
the below steps:
1. Open the door and press Programme
(2)
and Delay (4) buttons simultaneously
for 3 seconds.
2. When sound setting is recognized,
buzzer gives a long sound and machine
will display last set level, from “S0” to
“S3”.
3. To decrease sound level press
Programme button (2). To increase sound
level, press Delay button (4).
4. To save the selected sound level, turn
off the machine.
’’S0’’ level means all voices are off. Factory
setting is “S3”.