Ikra BF 25 - Troubleshooting Motor Faults

of the dirt off the device with a brush. Remove the guide
handle as explained in the „Assembly“ chapter.
Disposal and environmental protection
Should your tool become unserviceable or if you no
longer require it, do not dispose of it under any circum-
stances in your normal household waste, but rather in an
environmentally friendly manner. Empty the oil and petrol
tank carefully and take the leftover fuel to a collection
point. Please (also) take the tool to a recycling centre,
where the plastic and metal parts can be separated out
and sent for recycling. You can also obtain information
on this by contacting your local authority or city council.
Warranty
For this petrol tool, the company provides the end user
- independently from the retailer‘s obligations resulting
from the purchasing contract - with the following war-
ranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts and defects caused by the use of non t-
ting accessories, repair with parts that are not original
parts of the manufacturer, use of force, strokes and
breaking as well as mischievous overloading of the motor
are excluded from this warranty. Warranty replacement
does only include defective parts, not complete devices.
Warranty repair shall exclusively be carried out by au-
thorized service partners or by the company‘s customer
service. In the case of any intervention of not authorized
personnel, the warranty will be held void.
All postage or delivery costs as well as any other
subsequent expenses will be borne by the customer.
GB-9
RECTIFYING MOTOR FAULTS
PROBLEM POSSIBLE CAUSE REMEDIAL ACTION
The motor does not start, or starts Incorrect start procedure Note the information in
but does not continue to run. these operating instructions.
Incorrectly set Have the carburettor adjusted by
fuel/air mix on carburettor. authorised customer service.
Rusted spark plug Clean/adjust spark plug or replace.
Blocked fuel lter. Replace the fuel lter.
The motor starts but will not run at full Incorrect choke lever position. Set the lever to RUN (operation)
power.
Dirty air lter Remove lter, clean and insert anew.
Incorrectly set Have the carburettor adjusted by
fuel/air mix on carburettor. authorised customer service.
Motor runs unevenly. Incorrectly set spark gap Clean/adjust spark plug or replace.
on spark plug.
Incorrectly set carburettor Have the carburettor adjusted by
authorised customer service.
Excessively high noise. Incorrect fuel mixture. Use the correct fuel mixture (ratio 40:1)
Incorrectly set carburettor Have the carburettor adjusted by
authorised customer service.