Operating manual - English NOVA 2000
5
1 TRANSPORT
The NOVA 2000 key-cutting machine is easily transported and is not dangerous to handle.
The packed machine can be carried by two persons.
1.1 Packing
The packing used for the NOVA 2000 guarantees that the machine will travel safely without danger of
damage to it or its components.
The packing comprises two shells, lower and upper in expanded plastic in the machine is wrapped.
A strong outer cardboard box, the measurements of which can be seen in fig. 3 and the plastic wrapping
protect the machine even over a long period of storage.
Note: keep the packing and use it every time the machine must be transported.
Fig. 3
1.2 Transport
Symbols are printed on the outside of the cardboard box to give instructions and warnings for
transportation.
Use of the packing box whenever the machine is transported will avoid knocks or bumps which could
cause damage.
1.3 Unpacking
To remove the machine from the packing box:
1) cut the straps with scissors and remove.
2) open the box without damaging it as it may be used again (e.g. removals, dispatch to the
manufacturers for repairs or servicing).
3) check the contents of the box, which should comprise:
1 NOVA 2000 key-cutting machine packed in a protective shell.
1 set of documents, including: operating manual, spare parts list and guarantee.
1 accessory container.
1 connecting wire.
1 safety device (supplied with the 230V machines);
4) remove the key-cutting machine from the protective shell.
500 mm
600 mm
410 mm
Keep dry This side up
Handle with care
To Next Page
Loading...