NOVA 2000 Operating manual - English
6
1.4 Handling the machine
When the NOVA 2000 has been unpacked, place it directly on its workbench.
This operation can be carried out by one person.
ATTENTION: holding the base, and no other part, to lift and carry the machine.
1.5 Safety
• Protective shield
A special transparent plastic shield prevents chippings from flying into the air.
• Safety device
The device is connected to a power plug with a differential switch, power the key-cutting machine by
pressing the switch (X1).
The warning light (X2) illuminates to indicate voltage in the plug (X3).
ATTENTION: switch (X1) is electromagnetic, in the event of a power failure it goes out automatically. When
electricity is restored it must be reset manually to power the machine again by means of the plug
(X3).
To Next Page