7.1 SPECIFICATIONS
• Dimensions of the Meter: 119 x 65 x 35 mm.
• Weight: 213±3 gr. (Battery included).
• Screen: LCD 45 x 45 mm.
• Memory: 199 results / error messages with their date and
time.
• Power supply:
- Battery: Lithium 2400mAh/2800mAh; 3.7 V. Consumption: 1 A.
- Power supply: Only plug the charger to power supplies with
the following characteristics (Input): 100-240 V, 50-60 Hz,
Consumption: 0.2 A.
- Power supply (Output): 5 V dc, 1000 mA via a mini USB
connection.
• Battery life: *approximately 70 tests.
• Operation conditions:
- Temperature: 15ºC-35ºC.
- Maximum relative humidity: 80%.
• Meter storage temperature: -20ºC to 50ºC.
• Measurement range: 0.8 – 8.0 INR.
• Sample volume: at least 3µL.
• Data transfer via a mini USB connection.
* Test conducted at 22ºC with a 10 minute period between tests.
16
7. ADDITIONAL INFORMATION
7.2 CE DECLARATION OF CONFORMITY
This medical device complies with the standards and legal
requirements of Directive 98/79/EC of the European
Community for In vitro diagnostic medical devices, of 27
October 1998, and with Directive 2011/65/EU of the European
Parliament and Council (RoHS) of 8 June 2011 on restrictions
of use of certain hazardous substances on electrical and
electronic equipment.
7.3 WARRANTY
iLine Microsystems warranties to the original buyer that the
microINR system is free of material and manufacture defects
for two years aer the purchase date.
This warranty does not cover any component damaged due to
inadequate storage in environmental conditions outside the
defined range, accidents or modifications, incorrect use or
handling and misuse. The buyer must deliver a written
warranty complaint to the manufacturer within the
corresponding warranty period.
7.4 TECHNICAL SERVICE
If a problem persists aer performing the actions stated in the
table of errors or if you want additional information, you can
contact your local distributor.
To Next Page
Loading...
Need help?
General
