Mounting the Bar Speaker to a Wall
1. Use the TAPE MEASURE to decide how high
you’d like to hang the bar speaker on the
wall.
The bar speaker must be hung within 6 feet of
an AC power outlet for the attached AC power
cable to reach.
2. Use the STUD FINDER to locate 2 parallel
wooden studs to screw the mounting
brackets into.
3. Mark the wall at the center of the studs using
the PENCIL.
4. Line the LEVEL up on both of your marks to
make sure they are level. If they’re not, adjust
the marks as needed to make them level.
5. After you’ve double checked your markings,
DRILL through the top holes on the
mounting bracket directly into the pencil
marks you’ve made on the wall.
6. Use the LEVEL to level the mounting bracket,
then drill the remaining screws into the
bottom holes on the mounting bracket.
7. Slide the bar speaker onto the mounting
bracket, and make certain there is a rm and
stable connection before letting go of the bar
speaker.
8. Finally, use the LEVEL to conrm that the bar
speaker is level.
Mounting - Getting Started
To Next Page
Loading...
