making coffee
This model of the X1 machine is designed to function exclusively with illy “Metodo iperEspresso” capsules.
To make coffee, carry out the following steps:
- Turn the capsule holder to the left and remove it from the brew head 1.
- Insert the capsule as shown in gure 2.
Note: the capsule should slide easily into the compartment; if this is not the case take it out and reposition
it correctly.
- Insert the capsule holder in the brew head 3; turn the handle to the right until it locks into place 4.
- Check that the machine temperature LED is steadily lit (BLUE) 5.
Press down and release the coffee switch; the machine will brew the programmed quantity of coffee.
To stop the ow in advance, press the switch down again.
To make other coffees, remove the used capsule and repeat the steps just described.
Note: coffee is dispensed for about 3 seconds after you press down the coffee switch.
Warning:
- The capsules are single-dose and cannot be used to make two coffees.
- To ensure greater safety, the machine automatically stops ow after about one minute.
- Remember to empty and clean the drip tray frequently.
To Next Page
Loading...
