making hot water
1
5
43
The steam wand the machine is equipped with can also be used to heat up water for making tea and infu-
sions.
To make hot water carry out the following steps:
- Remove any capsules from the capsule holder 1.
- Clean the steam wand of any milk residues 2.
- Press the steam switch 3 down; the machine temperature LED will ash (GREEN) 3 to signal that the
machine is getting ready to dispense steam.
- When the machine reaches the right temperature, the machine temperature LED will remain steadily lit
(GREEN) 4 and a brief beep will be emitted.
- Fill a metal pitcher with the quantity of water you want to heat.
- Submerge the steam wand into the pitcher full of water
5
and open the steam knob by turning it
counterclockwise 6.
- Upon reaching the desired temperature close the steam knob by turning it clockwise 6.
Flashing - GREEN Steadily lit - GREEN
6
2
CAUTION:
While the machine is warming up and as long as it remains in the steam mode, it carries out heating cycles
in the boiler that may cause small amounts of steam to be discharged from the capsule holder: therefore,
keep limbs and other parts of the body away from the coffee brew zone in order to avoid scalding.
To Next Page
Loading...
Need help?
General
