1 2 4
5
6
7
3
Installation and start-up of espresso machine
Before connecting the machine to a power supply, carefully read the safety instructions given in the chapter:
“important safeguards”.
Make sure that the steam knob is closed and that the machine is unplugged 1.
Insert the capsule holder 2 from below and turn it to the right until it locks into place 3.
Pull the water tank out of the machine 4.
Fill the tank with fresh drinking water until the MAX mark is reached 5.
CAUTION: always fill the tank with fresh, still drinking water only. Hot water or other liquids may da-
mage the tank. Do not use the machine without water.
Fit the tank to the machine, making sure it is inserted completely in place 6.
Insert the plug into the outlet. Consult the following chapter to switch on the appliance.
CAUTION.
While the machine is operating, contact with the brew group D, the steam
wand N or the metal part of the capsule holder E may cause burns.
D
E
N
It is advisable to keep the original packaging (at least for the duration of
the warranty period) in order to ship the machine to an authorized service
center for repair if necessary.
To Next Page
Loading...
Need help?
General
