illy Metodo Iperespresso X1 - Making Coffee After Steam

35
making coffee after generating steam
3
5
1 2
While the machine is dispensing steam, the temperature LED will be
steadily lit (GREEN) 1.
To switch the machine back quickly to the coffee mode, carry out the
following steps:
- Press the coffee switch down 2.
- During the cooling down phase (approx. 10 minutes unaided) the
LED will ash (BLUE).
- Place a container beneath the steam wand 3.
- Discharge steam by turning the steam knob counterclockwise 4
until the machine emits a brief beep.
- The LED will become steadily lit (BLUE) 5.
- Close the steam knob by turning it clockwise 6.
- The machine is again ready to make an espresso.
If you do not carry out the steps just described, it will take a lot longer
to bring the machine back into the coffee brewing mode.
In this case, carry out the following steps:
- Press down the coffee switch 2.
- During the cooling down phase (approx. 10 minutes) the LED will
ash (BLUE).
- The machine will emit a brief beep.
- The LED will become steadily lit (BLUE) 5.
- The machine is now ready again for making espresso.
Flashing - BLUE
Steadily lit - BLUE
Steadily lit - GREEN
4
6
EN