24
INDICATION MACHINE STATUS
The buttons light up in sequence The machine has been turned on and is warming up.
+
Lit
The machine has reached the right temperature for brewing.
+
The espresso button fl ashes
The machine is brewing an espresso.
An espresso is being programmed.
+
The long espresso button fl ashes
The machine is brewing a long espresso.
A long espresso is being programmed.
Slow fl ashing
The machine is in the Power Save mode. The machine switches into Power Save
after 60 minutes when not used. To start the machine again just touch any button.
Dimming of illumination
The machine needs to be descaled.
Steadily lit (only the espresso button)
The machine is indicating that the descaling cycle has been selected. In this status
the tank should contain a descaling solution.
+
Flash alternately
The machine is indicating that the fi rst part of the descaling cycle is in progress.
Descaling solution is being run through the machine.
The espresso button alone fl ashes progressively.
Steadily lit (only the long coffee button)
The machine is indicating that the fi rst part of the descaling is over.
The tank must be rinsed out and fi lled with fresh drinking water.
+
Flash alternately
The machine is indicating that the second part of the descaling cycle is in prog-
ress. Water is being run through the machine to rinse out the circuit.
The long espresso button alone fl ashes progressively.
+
Rapid fl ashing
The machine has a malfunction. Turn it off and back on again after 30 seconds. If
the fault is signaled again, contact a service center.
To Next Page
Loading...
Need help?
General
