the oven thermostat to 250 °C
on conventional heating system
for 10 - 20 minutes.
Always ensure that you remove
excess trays, side racks and
the fat filter as any fat will burn
on these items making cleaning
extremely difficult. You may also
need to wipe the door and inner
glass if they have a lot of splatter
on them.
Leave the oven with the door
closed and in this time the fat
absorbed in the catalytic liners
will burn off the liners and the
elements.
Once the oven is cool you may
need to wipe the base of the oven
with a damp sponge to remove
the product of the burn off. Every
six months you must
wash the side liners to ensure
longevity.
The side liners can be washed in
hot soapy water and are to be
dried before placing them back in
the oven.
If you clean the enamel in your
oven it is essential that you use
a non caustic cleaner and spray
that cleaner onto a soft cloth
rather than spraying the cleaner
directly into the oven.
The fat filter at the rear of your
oven has to be cleaned on a
regular basis; the filter can be
cleaned by hot soapy water, or in
the dishwasher
3. Oven floor
removal
The entire floor of your oven is
removable for cleaning purposes.
Before floor removal your must
first remove all trays and racks
from the inside of the oven and
remove the centred thumb screw
on the side shelving racks. This
will enable you to lift the side
racks up and off the locating pins
and out of the floor hole locks,
which secure the floor into the
oven. The oven floor will then
simply slide out of the oven.
4. Removal of door
and inner glass
For ease of cleaning ILVE have
made their oven doors removable
so that the interior oven glass
can be removed and cleaned.
All ILVE ovens use easy clean
vitreous enamel interiors giving
a smooth black non staining
appearance.
a. Removal of door
Open the door and lift catches
(A) and hook into arm (B) on both
sides. Lift door gently upwards
(C), as if closing, using both
hands placed either side of the
outer glass edge and door should
loosen. Gently pull the door up
towards you, if force is needed
the door is not in the correct
position and you will need to
repeat the procedure. To refit the
door reverse the procedure.
b. Removal of
inner glass
ILVE oven doors are fitted with
athermic door glass panels, the
inner panels are removable. To
remove glass open the door and
unscrew the thumb screws (D&E)
located on the top of door,
remove top strip and gently
remove glass (F&G) before
washing in hot soapy water. The
interior glass can also be cleaned
with a damp cloth. When replac-
ing the glass it is important that
the silver coated surface faces in
towards the interior of the oven
and that the top strip is replaced
before screwing the glass back in
place.
15
A
B
C
D
E
F
G
To Next Page
Loading...