Switch off scanner
To switch the scanner to stand-by mode after performing the setup,
proceed as follows:
➢ On the Select Application screen, tap POWER OFF (1).
You can also press the POWER button briefly to access this menu. Do not
press the POWER button for longer than 5 seconds, otherwise the scanner
will switch off hard.
➢ Confirm with YES.
The scanner shuts down. This process can take up to approx. 40 seconds.
The scanner is in stand-by mode.
Alternatively, switch the scanner to stand-by mode as follows:
➢ Press the blue illuminated power button (2) and confirm the dialog
displayed on the touch screen.
The scanner shuts down. This process can take up to approx. 40 seconds.
The scanner is in stand-by mode.
To Next Page
Loading...
Need help?
General
