Risk of electric shock due to incorrect connection.
➢ Ensure that the power receptacle intended for the
connection is properly grounded.
➢ Ensure that the power receptacle intended for the
connection of the scanner is properly fused.
Incorrect laying of the connection cables can cause tripping.
Fractures, contusions and bruises can be the result.
➢ Place the connecting cables so that nobody can trip over
them.
To connect the power supply, proceed as follows:
➢ Make sure that the main switch of the scanner is switched off (0
position).
➢ Use only the AC adapter and power cord supplied.
➢ Ensure the power cord is not damaged.
➢ Connect the connector from the power supply to the associated 19 Vdc
connector on the back of the scanner.
➢ If not already done, connect the supplied power cable to the associated
connector on the power supply.
➢ Connect the power plug of the power supply to a power receptacle of
the correct voltage (100-240 Vac).
To Next Page
Loading...
