IP400, IP500 & IP600 7
· When the truck is full, lift the truck latch handle and pull the truck out of the
machine by its handle.
· Unlock the toggle clips at the front of the truck.
· Withdraw the truck liners by lifting vertically.
· Unfold the rolled over edges of the plastic bag and pull together.
· Twist the neck of the bag and fold a wire tie round the neck of the bag so that
the two loops on the tie come together. Then insert the hook of the tying tool
into both loops. Pull the handle and the tool will twist the wire tight, sealing the
bag.
· Fasten the toggle clips on the truck.
· Wheel the truck to the garbage storage area. Unfasten the toggle clips, open
the two truck doors and slide the bag out.
· Take care to re-engage the two doors correctly into the slots, close the toggle
clips and return the truck to the machine.
·
It is recommended that if the machine is not in use for long periods it is switched
off at the key switch.
OVERLOAD PROTECTION
Under extreme load circumstances the Compactor might overheat. The switchgear
contains an overload to prevent any damage to the motor. This device will
automatically reset itself when cool, and it will only be necessary to wait a few
minutes before the machine can be restarted.
Press the START button to reset and start the machine.
If any difficulty is encountered, please contact the supplier or the manufacturer.
MAINTENANCE
Keep the Compactor and the area around it clean at all times.
Remove the truck and then, by releasing the castor brakes, the unit may easily be
moved to clean the floor beneath and behind it. (NB. Switch off the electricity supply
at the isolator or unplug the unit before moving or cleaning).
It is advisable to clean the exterior stainless steel finish periodically with a stainless
steel cleaning agent or a soapy cloth.
Once a year the hydraulic oil level must be checked by a Service Technician. This
is done by removing the top and back panel, and checking the hydraulic oil level in
the Power Pack reservoir. The Power Pack reservoir has a label showing maximum
and minimum oil levels. These should be adhered to when checking levels.
Replace with SOLENT VG68 oil, or equivalent.
To Next Page
Loading...
Need help?
General