6 IP400, IP500 & IP600
OPERATING :
Preparing for Use
· Remove the truck by lifting the truck latch and pulling on the truck handle.
· Place an IMC bag into the truck and arrange for the bottom of the bag to cover
the base of the truck. Then fold the top edges of the bag over and around the
rim of the truck.
· Position the truck liners inside the bag.
·
Push the truck back into the machine.
It is recommended that only IMC Impactor bags are used to achieve best results.
Additional bags are available from IMC or its distributors.
Operation
· Turn the key switch to select the ON position.
· Select NORMAL or CONSTANT operation.
If NORMAL is selected the unit will cycle once only: the ram will move to the down
position, pause for four seconds and return to the fully up position where it will stop.
CONSTANT leaves the ram in the down position until released by turning the switch from
constant to normal. Use this mode for resilient material which has resistance to
compaction.
· Open the flap and place waste material into the truck. Waste may also be
placed into the truck before is pushed into the machine.
(A useful tip is to commence with some cardboard which then forms a solid
base in the bag. There is no need to sort waste, but it is not recommended to
compact large amounts of glass).
· Close the flap fully and press the START button, the run indicator will light while
the ram is moving or in the down position.
· The machine will not operate unless the truck is properly locked into position
and the safety flap is closed.
· To stop the machine at any point in its cycle press the STOP button.
To restart press the START button - the machine will continue its cycle.
· Continue compacting until the bag full light comes on. Bag full levels are
dependent on the type of waste being processed. Do not overfill the truck as
this makes it difficult to withdraw.
To Next Page
Loading...
Need help?
General