4 IP400, IP500 & IP600
To manoeuvre the IP400 truck: lift truck latch handle, raise the truck handle to the
high position, lift the latch handle and lower the truck handle to fit truck into
machine.
· Wheel the machine off its packing base.
· Inspect the machine carefully before disposing of the packing materials, and
check that the machine and any accessories have been delivered undamaged.
If anything is missing or damaged, please notify both the carrier and the supplier
within three days of receipt.
Warning: This machine has a high centre of gravity, take care when
manhandling it
Model Weight/kg Dimensions Cube
Gross Net cm m³
IP400 223 193 176x60x73 0.770
IP500 373 298 187x77x90 1.296
IP600 474 377 210x96x110 2.218
PREPARATION
Strip off the protective vinyl covering from the stainless steel sheeting. If appearance is not
an important factor it does no harm to leave this protection in place.
SITING AND INSTALLATION
For the installer:
These instructions contain important information designed to help the user obtain the
maximum benefit from the investment in an IMC Waste Compactor.
Please read them carefully before starting work, and consult with the supplier in the event
of any queries.
Please leave this Instruction Manual with the user after installation.
Procedure:
The Compactor is designed to reduce the volume of rubbish. The maximum advantage is
gained if compaction is carried out at the point at which the waste arises. This results in
minimum movement, reduced handling, and maximum cost savings. Alternatively, it is
possible to order extra trucks for larger establishments or waste segregation.
Ensure that the Compactor is located on a flat and level floor. Ensure that
sufficient additional space is available to allow the truck to be withdrawn. The front
pair of castors are fitted with brakes, which can be locked into position by
depressing the pedal. Push truck into machine, and ensure it is latched in.
To Next Page
Loading...
Need help?
General