1.8.3 Charging the Battery
Your TABLET comes with a wall/USB charger (charging head and USB cable) to
charge your TABLET from any 110/220 VAC outlet.
Note: The battery comes partially charged. You must fully charge the battery before
using your TABLET for the first time, a fully discharged battery requires up to 4
hours of charge time. After the first charge, you can use the TABLET while
charging.
1. Insert the USB cable into the port.
2. Connect the USB cable to the charging head.
3. Plug the charging head into a standard ac power outlet.
4. When charging is complete, unplug the charging head from the power outlet and
remove the USB cable from the TABLET.
1.9 Turning the TABLET On and Off
1.9.1 Turning the TABLET On
Press and hold the power/lock key until your TABLET vibrates and starts up.
Note: Your TABLET’s internal antennas are located along the top and bottom of the
TABLET, do not block the antennas; doing so may affect call quality or cause the
TABLET to operate at a higher power level than is necessary.
1.9.2 Turning the TABLET Off
1. Press and hold the power/lock key until the TABLET vibrates, and the device
options menu displays.
2. At the prompt, tap power off.
1.10 Setup Wizard
The first time you turn your TABLET on, setup wizard will guide you through the
basics of setting up your TABLET. Follow the prompts to choose a default language,
set up accounts, choose location services.
To Next Page
Loading...
Need help?
General