Page 13 of 46
• Check the accessories.
• The products listed in the components are compatible products.
5.1 Charging the Battery
Before using iSyncWave for the first time, fully charge the battery. Fully charging the battery may
take up to three hours. This will help extend the battery life of the device.
• Connect the USB-C charging cable to the charger.
• Plug in the charger to a power outlet.
• Connect the end of the USB-C charging cable to the USB-C charging port of iSyncWave,
which can be found on the bottom right side of the device.
• Place the device on a sturdy flat surface and make sure the bottom side of the device is
facing down.
• If the device is fully charged, the LED status indicator on the power button will be green.
The LED status indicator on the power button will indicate the battery status as follows:
5.2 Connecting iSyncWave and iSyncWave app
1. Press the power button and hold for more than 2 seconds to turn on the device
2. Run the iSyncWave app on the tablet
3. Connect your tablet to a Wi-Fi network through the settings panels of your tablet PC
4. Register the patient/subject under the iSyncWave app
5. Connect the iSyncWave device to the tablet via Bluetooth
To Next Page
Loading...