Blacktip II - User Manual
IMENCO AS Visiting Address: Kophaug 3, 5570 Aksdal, Norway Office: +47 52 86 41 00 imenco@imenco.com
Org No: 923 005 749 MVA Postal Address: PO. Box 2143, 5504 Haugesund, Norway Fax: +47 52 86 41 01 www.imenco.com
3
Contact
for assistance / clarification on any of the contents of this manual, please contact:
Imenco AS
Subsea Electronics
Kophaug 3
5570 Aksdal NORWAY
Tel: +47 52 86 41 00
E-mail: imenco@imenco.com
Safety information
IMPORTANT! The Imenco Blacktip II Subsea Camera is a technically advanced product.
Please make sure to read and understand all sections of this manual before installing or
operating this product. Installation of this product should only be performed by
qualified personnel.
WARNING! This product contains no user serviceable parts. Do not open, alter or
disassemble this product. Failure to comply with this warning can result in damage to
equipment and void of warranty. The camera is filled with inert gas at manufacture.
WARNING! The housing is NOT connected to any Protective Earth circuits.
The metal housing has no electrical contact with any of the circuits inside the camera.
This is to isolate the camera housing from other equipment that includes dangerous
high voltage and to minimize corrosion that otherwise might be intensified by electrical
contact to other nearby metal equipment or structures exposed to the sea water.
Warranty
Be sure to read and comply with Imenco’s Terms & Conditions that the Blacktip
camera was sold under.
To Next Page
Loading...