EN
16
END OF USE
Wait for the appliance to cool down completely before putting it away. The reservoir (1)
does not have to be emptied.
NOTES:
If the appliance is not to be used for several weeks, remove and empty the water
reservoir (1) completely.
TROUBLESHOOTING
This chapter describes the most common problems that can arise using the appliance. If the
problems cannot be solved with the information below, please call the freephone number or
contact an Authorised Assistance Centre.
Problem Possible cause Solution
The appliance does not go on. The household appliance is not on.
Make sure that the appliance is properly
connected to the socket, that the ON/OFF
button (6) is pressed and the light is on.
The plate temperature LED (14)
Normal procedure.
The switching ON and OFF of the LED (14)
indicates the heating phase of the iron. The
reached.
A little smoke comes out of the
appliance when it is switched on
This is absolutely normal and is due to the
expansion of the plastic material.
This no longer occurs after a while.
Impurities come out of the plate
This cannot happen with a new iron.
These particles are completely harmless
and will disappear after the iron is used a few
times.
The appliance does not produce
steam.
The appliance is not on. Press the ON/OFF button (6).
The steam button (16) is not being pressed.
Keep the steam button (16) pressed as you
iron.
There is no more water in the reservoir (1)
and the no water LED (11) is on.
Fill the water reservoir (1) (see chapter:
FILLING THE REMOVABLE RESERVOIR).
The water reservoir (1) is not positioned
correctly on the boiler and the no water
LED (11) is on.
Position the reservoir by making it slide on the
guides until it clicks into position.
The boiler cleaning LED (10)
been cleaned.
The ECO button (8) was not held
down long enough.
Hold the ECO button (8) down for at least 3
impurities or limescale residues
substances.
water (see the FILLING THE RESERVOIR
chap.).
The impurities or chemical substances
found in the water have deposited on the
plate.
Wait for the plate to cool down and clean it
with a damp cloth.
too high.
Wait for the plate to cool down and clean it
with a damp cloth.
An excessive amount of limescale and
minerals has accumulated in the boiler.
Clean the boiler (see the CLEANING THE
BOILER chapter).
To Next Page
Loading...
