Error message Solution
Error 2: Please clean the
cliff sensors and move
device to a new location.
Error 4: Please check and
remove any foreign
objects at the collision
sensor.
Error 3: Strong magnetic
interference detected.
Please move device to a
new location and restart.
Error 1: Please check that
the lidar is not covered.
Error 5: Abnormal
temperature. Please wait
for the device's tempera-
ture to return to normal.
Error 6: Charging error.
Please clean the charging
plates.
Please check and remove any foreign
objects near the lidar or move the
device to a new location and restart.
Please clean the cliff sensors and
restart (see the instruction manual for
the location of the sensors) or move
device to a new location and restart.
Please move the device to a new
location and restart.
Please try to press on the bumper and
remove any foreign object and restart.
The device’s temperature is too high or too
low. Please wait for its temperature to
return to normal and restart.
Please check if an original power
adapter is used and whether the
charging dock is placed on a level
surface. Please power off the device
and unplug the dock’s power cable
before wiping the metallic charging
plates.
Product name
Model no.
Dimension
Rated voltage
Rated power
IMILAB V1 Vacuuming Robot
CMSDJ707A
φ350mm × 98mm
14.4V
50W
Battery capacity 5200mAh
Wi-Fi connection Wi-Fi IEEE 802.11b/g/n 2.4GHz
Main device
Model no.
Rated power
Rated input
Rated output
950W
CMJCZ01
220V-240V
24V 1.2A
Rated frequency 50/60Hz
External dimension 356 × 250 × 193mm
Dust collection station
Basic parameters Troubleshooting
23 24
To Next Page
Loading...