Immergas CARV2 Instruction And Warning Book

6
OK
1,5m
NO
1
2
1. INSTALLATION.
1.1 Installation recommendations.
e CAR
V2
remote control, including the relative cables and
connections to the boiler, must be installed by specialised
sta. On the initial check of the boiler, when the CAR
V2
remote control is inserted into the system, the authorised
aer-sales centre checks the connection to the generator
terminal board and adjusts functioning.
Important: laying of the CAR
V2
remote control cables is
excluded from the boiler checks; it is the responsibility of
the installer company.
1.2 Installation operations.
1) Separate the xing template from the body of the CAR
V2
remote control using a screwdriver as a lever in the
relevant recess (Fig. 3). Install the CAR
V2
remote control
away from heat sources and in a suitable position to detect
the room temperature correctly (Fig. 1 and 2).
Note:
the presence on the rear of the remote control of the
pipe for electric connection cables with the boiler could
recall air from outside the establishment and interfere with
the correct detection of the room temperature (e.g.: boiler
installed outside and use of the suction hood in the kitchen).
Have the job carried out by qualied sta.
2) Install the CAR
V2
remote control using the holes made
in the rear of the same directly onto the wall (Fig. 4) or
on a recess box (Fig. 5) using the relative supplied screws.

Immergas CARV2 Specifications

General

Brand	Immergas
Model	CARV2
Category	Temperature Controller
Language	English