Immergas CRONO 7 - 4 Start-Up; Programming Current Day and Time; Selection of Functioning Mode

12
4.2 Selection of functioning mode
According to the functioning mode selected, the CRONO
7 performs the requests of the user, displaying the results
on the display.
By pressing the main selector button (ref. 6 g. 6) the
following functions can be selected:
- O;
- Anti-freeze;
- Winter / Chiller.
Note: the room anti-freeze function is active in the anti-
freeze and winter functioning modes.
• Off mode. The room anti-freeze function is not
guaranteed in this mode (the boiler anti-freeze function
remains active). e CRONO 7 is o but remains powered
and therefore the times and programs remain memorised.
4. STARTUP
4.1 Programming current day and time.
Switch the chrono-thermostat on by turning the main
selector onto one of the functions available.
Press the button to enter time and current time
mode and press the button to modify the settings.
On entering the programming mode, the time starts to ash.
Modify the hour and minutes by pressing the + / - buttons
and the button to conrm. Select the day of the week
and conrm using the button.
Once regulation has been completed, press the button
to escape the regulation mode.
Fig. 7