Immergas CRONO 7 - 9 Special Functions; Information; LANGUAGE (Language Selection); Chiller

22
9. SPECIAL FUNCTIONS
By pressing the button, a list of options is accessed
that allows to customise functioning of the CRONO 7,
according to the specic necessities.
To scroll the list, press the + / - buttons and press the
button to select the desired function.
9.1 INFORMATION
Press the button and scroll the options present until
“INFO” appears. By pressing the button, access a menu
that allows to verify the functioning state of the CRONO 7.
If a determined value is not present “--” will be displayed.
Press the +/- button repeatedly to scroll the list.
To go back to normal functioning mode, press the
button or wait 60 seconds.
e parameters that can be displayed are listed below:
- MANUTZ: Days remaining before periodic maintenance.
- FW VERS: e display shows the rmware version of the
CRONO 7
.
.
9.2 LANGUAGE (language selection).
It is possible to select the functioning language of the
CRONO 7. It is possible to select from Italian (ITA as per
standard) and English (ENG).
N.B.: e CRONO 7 is factory set in Italian, proceed as
follows to pass to English:
- Press the
button.
- Scroll the list of parameters, pressing the + / - buttons
until reaching“LINGUA”.
- Press the
button to select the function.
- Select “ENG” by pressing the + / - buttons.
- Conrm the selection using the
button.
9.3 CHILLER.
Allows to set the CRONO 7 for the management of a chiller
for cooling rooms:
- ON: cooling functioning;
- OFF: winter functioning.
9.4 REGOLAZ (Management of regulation parameter).
Allows to customise the functioning parameters of the
CRONO 7:
- DIMENS (dimension and building inertia), adjustable
from 1 to 20, as per standard set on 10. It establishes the
reaction speed of the system depending on the type of
system present. For example: