IMO *G3D-250 - Table of Contents; Safety and Table of Contents

3
READ THIS ENTIRE PAGE BEFORE PROCEEDING
FOR SAFETY OF PERSONNEL AND TO PREVENT DAMAGE TO EQUIPMENT, THE FOLLOWING
NOMENCLATURE HAS BEEN USED IN THIS MANUAL:
DANGER
Failure to observe precautions noted in this box can result in severe bodily injury
or loss of life.
WARNING
Failure to observe precautions noted in this box can cause injury to personnel by
acc
idental contact with equipment or liquids. Protection should be provided by
user to prevent accidental contact.
CAUTION ATTENTION
Failure to observe precautions noted in this box can cause damage or failure of
equipment.
Non compliance of safety
instructions identified by
the following symbol
could affect safety for
persons:
Safety instructions
where electrical safety is
involved are identified
by:
Safety instructions which
shall be considered for
reasons of safe operation
of pump and/or protection
of pump itself are marked
by the sign:
ATTENTION
ATTENTION
If operation of pump is critical to your business, we strongly recommend you keep
a spare pump or major repair kit in stock at all times. As a minimum, a minor
repair kit (o-rings, gaskets, shaft seal and bearings) should be kept in stock so
pump refurbishment after internal inspection can be accomplished.
Table of Contents
Seal Chamber Priming………………………………………………………………………………….2
Safety and Table of Contents ..................................................................................................... 3
A. General Instructions, introduction, Description of Equipment ................................................ 4
B. Assembly Drawing List and Mechanical Seal Types…………………………………………….5
C. Pump Model Identification, Ordering Instructions .................................................................. 6
D. Operating Limits ................................................................................................................... 7
E. Parts Lists ......................................................................................................................... 8-9
G. Pump Disassembly and Reassembly (Pumps with seals) ................................................... 10
H. Mechanical Seal Information ......................................................................................... 17-23
I. Pump Disassembly and Reassembly (Packing Pumps) ................................................. 24-26
J. Troubleshooting, Field and Factory Service and Parts ........................................................ 26
K. Assembly Drawings ....................................................................................................... 27-35
L. Imo Address and Phone Numbers ...................................................................................... 36