STEP 3 (See Diagram 3)
A.) Attach the Leg Developer Holder (#2) to the Main Seat Support (#1). Secure it with
one M10 x 5/8” Allen Bolt (#40) and Ø ¾” Washer (#39) from the top, two M10 x 3 ½”
Carriage Bolts (#48), two Ø ¾” Washers (#39), and two M10 Aircraft Nuts (#50) from
the side.
B.) Attach the Leg Developer (#12) to the Leg Developer Holder. Secure it with one Axle
(#18), two M10 x 5/8” Allen Bolts (#40), and two Ø ¾” Washers (#39).
C.) Attach an Olympic Sleeve (#28) onto the weight post on the Leg Developer. Attach a
Spring Clip (#37) to the Sleeve.
D.) Insert the Arm Curl Stand (#6) into the top opening on the Leg Developer Holder. Use
a Lock Knob (#36) to secure the Stand at desired height.
DIAGRAM 3
26
To Next Page
Loading...
