impro IXP20 - Controller Display, Status & Installation

ISC304-0-0-GB-06
April 2011
Page 4
Display (ISC921 Only)
Type ...............................
Thin Film Transistor Liquid Crystal Display
(TFT-LCD).
Resolution.......................
240 x 320 Pixels.
Colour .............................
65 K Colour Screen.
Back-lighting ...................
Permanently on.
Status LED
Power On........................
Continuous Red.
Upgrade Mode ................
Flashing Red.
Incoming RS485 Data ............
Flashing Green LED.
Outgoing RS485 Data ............
Flashing Red LED.
Digital Inputs (1-4) ..................
Continuous Green on detected contact
closure.
Relays (1 and 2) .....................
Continuous Red on activation of the Relay.
Locked ...................................
Continuous Green when locked.
Unlocked ................................
Continuous Green when unlocked.
Enet Act (Ethernet Activity) ....
Flashing Red LED.
Enet Spd (Ethernet Speed) ....
Continuous Red for 100 Mbps (Default)
Off for 10 Mbps.
Enet Lnk (Ethernet Link) ........
Continuous Red on connection to network.
INSTALLATION INFORMATION
Accessories
CAUTION: The IXP20 Controller needs a standard Ethernet cable to connect to
a PC. We do NOT however supply this cable with the Controller’s
accessories.
Find the following when unpacking the ImproX IXP20 Controller:
 Either an ImproX IXP20 Twin Reader Controller with Web Interface (ISC920)
supplied in a Black ABS Plastic housing. The housing consists of a Front Cover
Assembly and a Mounting Plate. The Front Cover and Mounting Plate are held
together with two Combi Screws (M4 x 10 mm) at the bottom of the housing.
 There are also two spare Combi Screws (M4 x 10 mm).
 Or, an ImproX IXP20 Twin Reader Controller with Touch Screen (ISC921)
supplied in a Black ABS Plastic housing. The housing consists of a Front Cover
Assembly and a Mounting Plate. The Front Cover and Mounting Plate are held
together with two Combi Screws (M4 x 10 mm) at the bottom of the housing.
 There are also two spare Combi Screws (M4 x 10 mm).
CAUTION: DO NOT use the Metal-oxide Varistors (25 Vrms, 500 A, 77 V max
clamping) with mains power applications.
 Three Metal-Oxide Varistors, 25 Vrms, 500 A, 77 V max clamping.
 A 3 V, CR2032, Lithium cell Battery.