IMT Analytics FlowAnalyser Series - Device Operation; Switching On and Basic Controls

23
Operation
6
IMT Analytics AG
Checkto make sure all the cables and tubesare connected proper-
lyand check compliance with the specifications (5 Start-up)
The device is switched on and off using a 0/1 switch on the back of the device.
If FlowAnalyseris switched on, thewelcome screen appears. After three seconds the
display with the numerical readings appears.
If you wish to change the language of the device delivered, please use the language
selection function (6.16 Set language).
Thequality of display depends on theangle of view. To optimise the quality for read-
ing purposes the contrast must be adapted to the angle of view.
Contrast can be adjusted by pressing the two marked buttons simultaneously.
6 Operation
6.1 Switching the device on and
off
6.2 The Start screen
6.3 Change contrast