Inboard M1 - START RIDING; CONNECTING YOUR POWERSHIFT BATTERY

CONNECTING YOUR POWERSHIFT BATTERYSTEP 1
Rotate the Battery Bay latch
counter-clockwise. Open and
remove Bay Door.
DO NOT RIDE M1 WITHOUT A
BATTERY INSIDE THE
BATTERY BAY. YOU MAY
CRACK OR BREAK THE
BATTERY BAY DOOR.
Place PowerShift Battery directly
down into the Battery Bay. Align
hole at top of battery with post
in the battery bay.
Gently slide back until engaged.
Close Door and secure latch.
Bay Door will not close unless
battery is fully engaged.
Do not force door closed.
When the battery is properly
installed, your M1’s LEDs will
flash once.
Your board is ready to be
paired.
START RIDING
| 8