EasyManua.ls Logo

Indel Webasto Marine Isotherm Built-In Series - 2.2 Usage Recommendations

Indel Webasto Marine Isotherm Built-In Series
230 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
User Manual
16
Models BI29, BI41 and BI92, called “Dual”, have a B thermostat and can be used both as
refrigerators and as freezers within the following temperature range:
BI29 Dual from +10°C to -12°C
BI41 Dual from +10°C to -10°C
BI92 Dual from +10°C to -20°C
2.2 Usage recommendaons
If possible, the product should be turned on for about 6 hours prior to inserng
the food items.
Frequent opening of the product will result in greater power consumpon.Frequent opening of the product will result in greater power consumpon.
Ensuring adequate venlaon for the compressor and the condensing unit will
signicantly reduce power consumpon.
Never obstruct the product’s venlaon system.
The electrical system must be kept in good condion. Inspect the baeries and
check the charge levels regularly. Always use a starter baery separate from the
motor.
Keep the inside of the product clean and dry. Remove the condensaon water
from the drip tray beneath the refrigerators freezer compartment where
present.
The product has been designed with a lock protecon for the product itself in
the event of low baery voltage. In the event of a compressor block, follow
the instrucons in this manual and/or contact specialised technicians or Indel
Webasto Marine Srl service centres.
The compressor can operate up to an angle of 30°, while greater angles can
cause permanent damage to the compressor.

Table of Contents

Related product manuals