Indel Webasto Marine Isotherm Built-In Series - Page 27

User Manual
26
The fuse blows. The wrong fuse is being used.
Defecve electronic control
unit.
Check the fuse: see table in secon 5.4.
Replace the electronic control unit.
The compressor is operang
intermiently.
Baery low or electrical cables
in poor condions.
Check wiring condions, examining for
loose connecons, rust or verdigris. If
wiring needs to be replaced, see the
manual for correct sizing. If wiring is in
good condions, check baery funcon
and replace if in poor condion.
The compressor never stops
(correct fridge performance)
Incorrect thermostat
connecon on the electronic
control unit. Thermostat
broken. Condensaon is not
working properly, evaporator
cools but not enough to cause
the thermostat to stop the
compressor.
Rotate the thermostat to o posion. If
the refrigerator connues to funcon,
then there is connuity on the control
unit. Correct the problem on thermostat
connecons (make sure the bridge
is present on C and P and not on C
and T on the electronic control unit).
Rotate the thermostat to o posion.
If the compressor switches o but it is
impossible to regulate temperature,
replace the thermostat or recharge the
cooling system.
The compressor never stops
(poor fridge performance)
Environment very hot +
insucient venlaon or lile
gas in the refrigerant circuit.
Check venlaon. The compressor must
be installed in a well-venlated locaon.
If possible, remove the refrigerator from
the installaon hole. If the refrigerator
operates beer, improve venlaon,
consulng the manual for correct
installaon. If venlaon is instead
opmal, check for the presence of gas
in the system, contacng a specialised
technician.
The freezer compartment
is cold but the refrigerator
is not
Insucient venlaon,
lile gas in the refrigerant
circuit, electrical power not
connuous.
Check venlaon. The compressor must
be installed in a well-venlated locaon.
If possible, remove the refrigerator from
the installaon hole. If the refrigerator
operates beer, improve venlaon,
consulng the manual for correct
installaon. Check electrical connecon
and baery condions. If venlaon is
instead opmal, check for the presence of
gas in the system, contacng a specialised
technician.