12 of 20
Service Manual UK
Indesit
Company
English
FAULT CODES - Basic
If there is a fault (active):
The service technician will find the machine immobilized, with the Fault indicator LEDs permanently
alight and other LEDs on the Control Panel blinking (usually On/Off, Salt and Rinse Aid).
Digit and LCD display models will show the Fault Code in the display.
Refer to the Fault Code chart below for guidance.
If Warning or Last Fault is indicated:
Starting the autotest, the last Fault or the current Warning will be displayed for 20 seconds.
Once this time has elapsed, the autotest sequence starts automatically.
If the autotest reaches the end, the Last Fault will be reset.
Should the Autotest procedure be interrupted for whatever reason, data in the Last Fault memory will
be saved. N.B.: The "Last Fault detected electronically" will always be displayed.
Basic Fault Code Chart
For more detailed information refer to next page.
Fault Possible Cause
LED Combination
LED 1 LED 2 LED 3 LED 4
1
ANTI-FLOODING OVERFLOW
On Off Off Off
2
WATER FILL SOLENOID VALVE FAILURE
Off On Off Off
3
DRAIN TIMEOUT
On On Off Off
4
THERMISTOR (NTC) not compliant
Off Off On Off
5
PRESSURE SWITCH non compliant
On Off On Off
6
WATER FILL TIMEOUT
Off On On Off
7
WATER TURBINE damaged
On On On Off
8
TEMPERATURE TIMEOUT (1 hour)
Off Off Off On
9
Software recognition error.
On Off Off On
10
HEATING ELEMENT CIRCUIT not compliant
Off On Off On
11
WASH PUMP Failure
On On Off On
12
COMMUNICATION error between main board and display
Off Off On On
13
MAIN BOARD not Working
On Off On On
15
VIRTUAL SENSOR - Inconsistent readings
On On On On
LED 1
LED 2
LED 3
LED 4
LED 1
LED 2
LED 3
LED 4
LED Models - Fault Code LED positions
To Next Page
Loading...
