1-2
Indmar Marine Engines
Fresh Water Cooling System – If equipped, the heat
exchanger has four drain plugs; two for raw water and
two for coolant. Refer to Chapter 7,
Storage and
Winter Lay-up
.
Figure 1.2 – Anti Knock Sensor
3. Make sure your battery is fully charged and the
cables are clean and tight.
4. Check engine oil for correct level. Refer to Chapter 6,
Maintenance
.
Figure 1.3 – Engine Dipstick Level
5. Check transmission oil level for correct level. Refer to
Chapter 6,
Maintenance
.
6. If your engine is equipped with fresh water cooling,
check the expansion tank for the correct level. Refer
to Chapter 6,
Maintenance
.
Do not mix antifreeze types.
7. Inspect engine mounts to make sure they aligned and
tight. Make sure that the propeller shaft coupler bolts
are tight.
Make sure the engine water intake is not
blocked by the trailer bunk. Blocked or
restricted water flow may damage the engine.
IND-A005A
1
To Next Page
Loading...
Need help?
General