Indmar Marine Engines
1-3
8. Back trailer into the water. Make sure the engine
water intake is submerged.
Before starting engine operate bilge blower
at least 4 minutes and raise engine cover to
ventilate fumes. Inspect engine and compart-
ment for any fluid or fuel leaks. Failure to do
so can possibly result in fire and/or explo-
sion resulting in death or serious injury to
you and your passengers.
Figure 1.4 – Raised Engine Cover
NOTICE
Priming the EFI Fuel System
is required before starting
your EFI engine for the first
time. This allows the electric
fuel pump to fill the fuel injec-
tion lines with gasoline. Each
time you advance the ignition
switch to the “ON” position,
the fuel pump cycles for 2
seconds.
9. Prime the fuel system by
cycling the fuel pump eight
to ten times before the
engine is started for the first
time. To prime:
• Turn the ignition key ON
for 5 seconds.
• Turn the ignition key OFF for 5 seconds.
• Repeat above eight to ten times
NOTICE
The above procedure is only necessary for the first
time the engine is started or in the event the fuel tank
is run dry.
To Next Page
Loading...
Need help?
General