Electrical connections
sh. 12 of 26
3.4 Mirror Port
The mirror port has a 1000Base-TX RJ45 interface. All telegrams of
the PROFINET can be recorded at this port by an Ethernet telegram
analyzer. .
IMPORTANT:
THE PC USED FOR DATA RECORDING MUST HAVE
1000BASE-TX RJ 45 INTERFACE (GIGABIT).
3.5 NETWORK IN
The NETWORK IN port renders the connection between the control
system and the PROFInet-INspektor
®
. To this end it is necessary to
connect the control system directly with the INspektor
®
via a RJ45
PROFINET cable.
3.6 NETWORK OUT
The NETWORK OUT port connects the PROFInet-INspektor
®
with
the entire system network.
IMPORTANT:
The "NETWORK IN" AND "NETWORK OUT" PORTS ARE FIRMLY
CONNECTED WITH EACH OTHER. IT MEANS THAT THE
PROFINET NETWORK KEEPS RUNNING EVEN IF THE POWER
FAILS OR THE PROFINET INSPEKTOR IS DEFECTIVE.
3.7 RESET button
A RESET button is provided on the rear side of device. This button
can be used to reset all settings to the initial status. For this purpose
press the button for at least 10 seconds.
IMPORTANT:
‘ANY RESETTING OF THE DEVICE ALSO RESETS THE
LICENCE. DO NOT FORGET TO SAVE IT BEFOREHAND.
To Next Page
Loading...