14 – Inepro Metering – PRO Series
6.7 Changing the CT-ratio (only CT versions)
6.7.1 On MID certified meters,
The initial screen after powering up, will be the warning to setup the CT ratio for this meter.
In default (when not doing any setting) the meter will operate in a 5/5 configuration.
To change the setting choose the applicable value (press the right button) from below list.
To store this setting: hold the buttons for 30 seconds. This will store the selected value
permanently!
6.7.2 Available settings.
The available settings on the CT-version meter are as followed:
ratio Choose
5/5 5
40/5 40 600/5 600
50/5 50 800/5 800
60/5 60 1000/5 1000
75/5 75 1250/5 1250
100/5 100 1500/5 1500
125/5 125 2000/5 2000
150/5 150 2500/5 2500
200/5 200 3000/5 3000
250/5 250 4000/5 4000
300/5 300 5000/5 5000
400/5 400 6000/5 6000
500/5 500 7500/5 7500
6.8 Back light
The meter is equipped with a blue backlight.
6.8.1 Change the back light setting
Press the right button for 5 seconds during the display of page BL btn and release the button
After releasing the button the backlight will blink twice OFF/ON to indicate you are in programming
mode.
To Next Page
Loading...
