Inepro Metering – PRO Series 1 – 15
Press the button to select the backlight mode;
bl btn Press button to activate light
bl off Always OFF
bl on Always ON
After choosing the desired scrolling time release the button and wait 10 seconds to program the new
data in the meter.
6.8.2 Day counter reset
The meter is equipped with a day counter for consumed energy. This is the energy forward calculated
and can be reset to zero by the user
6.8.3 How to reset the day counter back to 0
Press the right button for 5 seconds during the display of page kWh 0 and release the button
After releasing the button the backlight will blink twice OFF/ON and the register is reset to 0.
6.9 S0 pulse output
The energy meter is equipped with two pulse outputs (forward and reverse) which are optically isolated
from the inside circuit. It generates pulses in proportion to the measured consumption for purpose of
remote reading or accuracy testing. The pulse output is a polarity dependent, open-collector transistor
output requiring an external voltage source for correct operation. For this external voltage source, the
voltage (Ui) should be lower than 27V DC. The maximum switching current (Imax) is 100mA. To connect
the impulse output, connect 5-27V DC to connector 18/20 (collector), and the signal wire (S) to
connector 19/21 (emitter).
pin 18/20 (collector)
pin 19/21 (emitter)
To change the pulse output you need to purchase a IR eye head and PC software from your dealer.
Selectable S0 output rates are mentioned in paragraph 6 specifications.
To Next Page
Loading...
