Infasecure CS2113 - Base Installation Methods

16
Base
Setup
Infant Seat
IMPORTANT
!
• Consult the car owner’s handbook for the location of the ISOFIX anchorages
(if equipped).
• Consult the car owner’s handbook for the location of the top tether anchorage
points.
If there is no child restraint anchor tting or child restraint anchor point refer to Page
49-50 for the installation of the anchor tting.
CS2013 Infant Carrier
Seatbelt installation only
CS2113 Infant Carrier
Either Seatbelt or ISOFIX compatible
installations
CS2013 Infant Carrier seatbelt installation only
CS2113 Infant Carrier both seatbelt and ISOFIX compatible installations
The Base Unit contains the installation method for your vehicle.
You can use either;
Seatbelt Assembly – refer to ‘Installing Using Vehicle Seatbelts’ (Refer to Page 21)
or (if your vehicle has the ISOFIX anchorages)
Lower Anchorage Connector (LAC) straps, which contain ISOFIX compatible connectors and
tension indicating adjusters for each side of the base. - refer to ‘Installing Using Flexible
ISOFIX Lower Anchorage Connectors (LAC) (Refer to Page 23).