30
Place the Infant Carrier on a at surface.
Ensure the carry handle is folded out of the way and
the Hood is fully opened, to enable complete access
to the seat (refer Figure 1).
Loosen the harness straps by pressing the harness
adjuster whilst pulling on both harness straps (refer
Figure 2).
To release the buckle. Press the red button.
Lay the two harness straps (with tongues) to the sides
of the Infant Carrier (refer Figure 3).
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Preparing the Harness
Use
Infant Seat
Place the infant into the Infant Carrier, at on their
back, with the buckle positioned between the legs.
Check to determine whether the harness shoulder
straps are in the correct shoulder slot height (refer to
sections ‘Correct Slot Height’ and ‘Adjusting
Shoulder Strap Height’ on Page 25).
Adjust as required.
Step 6:
Step 7:
NOTE:
A new born or very small infant will require the
installation and use of the infant insert and pillow
to ensure correct fitment (see Set Up Infant
Carrier refer Page 27).
IMPORTANT
!
Always remove the infant from the Infant Carrier
prior to any adjusting shoulder heights
Figure 2
PULL
PRESS
PRESS
Figure 3
Figure 1
To Next Page
Loading...
