27
The Carrier
Setup
Infant Seat
The shoulder straps must be in the slots which
are nearest to the infant’s shoulders, but not
lower than the infants shoulders.
IMPORTANT
!
METAL
SPREADER
PLATE
Figure 6
GATES
The harness shoulder straps go directly from the
shoulder slot holes to the spreader plate. Thread
each shoulder harness strap back onto the metal
spreader plate through the gates (see Figures 6 & 7).
NOTE: Ensure the harness straps are not twisted.
Adjusting Shoulder Strap Height
Step 5:
Figure 7
Step 1:
Step 2:
Push the ends of the harness
shoulder straps rst through the
Pillow and then through the Insert
(ensure that this is
done for both sides).
Then through the appropriate
shoulder slot holes in the
cover and seat shell.
Following “Step 4” above the following
applies;
1
2
3
For newborn or small infants
To Next Page
Loading...
