Infasecure CS4310 - Converting to Child Seat: Recline & Padding; Setting Reclined Position; Child Seat: Upper Anchorage Adjuster; Adjuster Assembly Location (Forward Facing)

Adjuster
position
CHILD
WITH INBUILT HARNESS
CONVERTING TO CHILD SEAT
Ensure the recline section is swung
rearward (see Figure 1).
At the front of the restraint is a red
lever. Pull red lever forward and slide
the seat to obtain the desired upright
or reclined angle.
SELECTION OF APPROPRIATE PADDING COMBINATIONS
Determine whether your infant/child requires the additional padding provided with this restraint, to
ensure a safe and snug t in the restraint. Refer to page 6 for suggested padding combinations.
CHILD
WITH INBUILT HARNESS
ADJUSTER ASSEMBLY LOCATION
PUSH
Pull excess strap through the top section
whilst feeding the adjuster section towards
the seat (see Figure 2).
Continue to shorten until you have reached the
desired position at the rear of the restraint (see
Figure 3).
Step 1:
Step 2:
Forward Facing (Type B)
Adjuster
1
1
2
2
Upper Anchorage Strap
Figure 2
Front
of Car
Figure 3
RECLINED POSITION
- Refer to the shoulder height labels
(As shown on pages 21-22).
- For correct shoulder strap slot
height refer to page 25.
IMPORTANT
!
24