BOOSTER
WITH LAP-SASH SEAT BELT
the backrest adjust the headrest described in setup
to best suit your child (refer page 35)
USING LAP-SASH SEAT BELT
35
The red “Booster Seat belt Path” labels are located
each side of the Booster seat and at the headrest
(as shown on page 33).
Position the lap section of the vehicle seat across the
child’s lap then insert the buckle tongue in the belt
buckle (A).
USE
Pull the lap belt tight by rst pulling on the lap belt in
the direction of arrow 1 (refer Figure 1). Pull the sash
belt tight in the direction of arrow 2 while holding the
belts tight, attach the Safe Grip red belt clamp (B) on
the sash section, as close as possible to the buckle &
tongue assemblies (A) (refer to Figure 2 and Instruc-
tions for installing the Safe Grip red belt clamp).
DO NOT USE WITH JUST A LAP BELT.
You must use a lap-sash seat belt.
IMPORTANT
!
Ensure that you use the BOOSTER SEAT
BELT PATH indicators, marked in “red”.
A
B
WARNING
!
Figure 1
TOGGLE
SECTION (2)
LAP SECTION
BARREL SECTION (1)
SAFE GRIP (B)
(red belt clamp)
ATTACH TO
SASH SECTION
ONLY
SASH SECTION
BUCKLE (A)
(AND TONGUE)
Figure 2
37
To Next Page
Loading...
