12
tina48e1-c (2017-10) MPG400-401.om
Make sure the vacuum connection is properly made (→ 9).
Connect the sensor cable to the gauge and the controller.
Make a sensor cable according to the diagram.
Electrical connection
8-pin
FCC-68
connector
Pin 1 Supply (15 … 30 V (dc)
Pin 2 Supply common
Pin 3 Signal output (measuring signal)
Pin 4 Identification
Pin 5 Signal common
Pin 6 Status
Pin 7, 8 n.c.
Connect the sensor cable to the gauge and the controller.
3.2 Electrical Connection
Precondition
3.2.1 Use With an INFICON
Controller
3.2.2 Use With Another Control
Device
To Next Page
Loading...