3
English
NOTE: Sensor must be installed before using TEK-Mate.
Included in the package:
• TEK-Mate
• Plastic carrying case
• Two “D” cell alkaline batteries
• TEK-Mate sensor
• Replacement filters
1. Install two “D” cell alkaline batteries (included)
a. Depress the release tab using a coin or screwdriver.
b. Slide the battery cover away from the probe tip to remove.
c. Insert batteries as shown on the illustration inside the battery
compartment.
d. Replace the battery cover. Be sure to slide the battery cover
along the side rails until the release tab is engaged.
2. Installing sensor (included)
a. Remove rubber sensor cap from TEK-Mate body by gently
prying at the edges.
b. Remove TEK-Mate sensor from foil package and remove
protective foam.
c. Carefully install sensor into three-pin socket on circuit board.
d. Reinstall rubber sensor cap.
3. Turning TEK-Mate on and preparing for use
a. Long press the power button to turn TEK-Mate On or Off. The
POWER indicator will illuminate while TEK-Mate is On.
NOTE: If the POWER indicator flashes or if the POWER and
HIGH indicators both flash, the batteries are low and
should be replaced.
b. Allow TEK-Mate to warm up from 30 seconds up to two minutes.
NOTE: TEK-Mate will continually alarm during warm-up and all
three indicators will illuminate. When warm-up is
complete, TEK-Mate will beep and the HIGH indicator
will flash approximately once per second.
To Next Page
Loading...
Need help?
General
