Why is my Inficon Security Sensors TEK-Mate not finding leaks?
Your Inficon Security Sensors TEK-Mate might not be finding leaks because the sensor has reached the end of its useful life and needs replacement, or the power switch is set to LOW instead of HIGH. If the power switch is set to LOW, set it to HIGH and scan for the leak again.
What to do if my Inficon Security Sensors TEK-Mate responds slowly to a leak?
If your Inficon Security Sensors TEK-Mate responds slowly to a leak, the filter might be dirty or wet and needs replacing. Another possible cause is a failure in the pumping system. Turn the TEK-Mate on and listen for a high-pitched motor sound; if you do not hear the motor, it might indicate a problem. Also, ensure the sensor cover is properly installed.
General| Detection Method | Heated Diode |
|---|---|
| Response Time | Instantaneous |
| Gas Type | Refrigerants |
| Sensitivity | 3 g/yr |
| Sensor Type | Heated Diode |
| Operating Temperature | 0°C to 50°C |
To Next Page
